Equipment Fabrication Inspections 
Construction Marketing
JULY 14, 2022
There are several different options including concrete, metal, and fabric. Concrete buildings can withstand more environmental wear over time, while metal buildings are low on maintenance, and fabric buildings can be put up and taken down easily. . With metal buildings, they should be inspected and cleaned once a year.
The Constructor
MARCH 19, 2012
Steel: Steel is also used in pre-fabricated formwork. Purpose made steel forms are fabricated when dimensional tolerances are critical, or when the forms are planned to be re-used. Aluminium: Often used in pre-fabricated formwork, that is put together on site. waffle floors).
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
The Constructor
MARCH 19, 2012
Its importance is evident when you consider that the cost of fabrication, erecting and striking the formwork, often exceeds the cost of the concrete it is designed to shape and support. Always inspect the formwork prior to pouring. It can be handled safely and easily using the equipment available.
The Constructor
NOVEMBER 19, 2011
2) poor communication between the fabricators and erectors. (3) The most common causes of structural failures are: (1) Poor communication between the various design professionals involved, e.g. engineers involved in conceptual design and those involved in the supervision of execution of works. (2)
The Constructor
NOVEMBER 7, 2011
Reinforcement was fabricated and fixed along with post tensioned mono strands (encased in HDPE pipe) to profile. After fabricating and fixing shuttering in position, micro concrete encasement was carried out throughout the core holes in the slab. End anchors of post tensioned strands were fixed in position.
The Constructor
NOVEMBER 11, 2011
The displacement can be computed as ……………. (1) In such cases, applying the principle of virtual work, ………………….2(a) 2(a) Where, = change in length of member k, = change in thermal expansion of member K = change in temperature.
The Constructor
AUGUST 23, 2012
The metal should have good workability but also keep its strength during fabrication. The metal should normally be specified from standard widths and thickness. Non standard materials are difficult to purchase and also very expensive. Green part in the drawing represent restraint fixing and blue part as load bearing fixing.
Expert insights. Personalized for you.
206 
Let's personalize your content